1·Usually, 50-100 ms delay time is normal.
通常来讲，50 - 100毫秒的延迟时间都属于正常的范围。
2·Delay time will affect its dry density.
延迟时间影响其干密度。
3·The influence of delay time on the dynamics of the system.
延迟时间对系统动力学的影响。
4·Several methods are proposed to reduce the jitter of delay time.
最后对进一步提高延迟时间的稳定性提出了若干改进措施。
5·Interestingly, delay time is a big factor in choosing an alternative.
有意思的是，在决定要做出什么样的选择时，拖延的时间才是最重要的因素。
6·The relation of the couple range and the delay time are discussed.
也给出了同步时耦合参数范围和时间延迟的关系。
7·Papermaking process is very complex and there exists long delay time.
造纸生产过程中的定量／水分控制十分复杂，存在着大时延的问题。
8·Adjusting delay time and gas pressure can reduce the warpage of the part.
工艺上可以通过调整延迟时间和气体压力来减小产品的变形量。
9·The delay time between plating completion and baking start typically is observed.
电镀后和烘焙开始之间的间隔时间一定要严格控制。
10·The ignition temperature and ignition delay time decreased with the increasing radiant heat flux.
结果表明，随着辐射热能流率的增加，着火时间缩短，着火温度降低；
1·It is difficult to have good performance for chain boiler combustion control system due to large delay time, varying coal's quality and steam load.
大纯时延、煤种多变和蒸汽负荷频繁变化是链条炉难以进行良好燃烧控制的原因。
2·Several design methods and their experimental results are introduced. Design of acoustic cascade is firstly put up, which is effectively used in 1024 bits long delay time SAWTDL construction.
介绍了1024位声表面波抽头延迟线（SAWTDL）的几种设计结构及试验结果。其中声学级联结构为首次提出，是解决高位、长时延SAWTDL设计的行之有效的结构。
3·BP algorithm replaces the concept of phase with delay time, so it is irrelevant to frequency and the problem of range migration correction does not exist.
BP算法由于用时延代替了相位的概念，故与频率无关，不存在距离徙动校正的问题。
4·Finally, the relationship between buffer capacity, mean delay time and the jam radom of system is discussed.
最后，文章中讨论了缓冲器容量、平均时延与系统阻塞概率之间的关系。
5·Simulation results show that the scheme can guarantee the stability and improve the operation performance to a certain extent if the delay time is identified accurately enough.
仿真结果表明，只要对时延的辨识足够精确，该方法能够在保证系统稳定的前提下一定程度上提高系统的操作性能。